What are the valid input voltage ranges for your MCU with V DD 3. See Answer See Answer See Answer done loading.
Arduino connectors on NUCLEO-F401RE and NUCLEO-F411RE. This problem has been solved Youll get a detailed solution from a subject matter expert that helps you learn core concepts. December 2017 DocID025833 Rev 12 1/69 1 UM1724 User manual STM32 Nucleo-64 boards Introduction.
NUCLEO F401RE REFERENCE MANUAL INSTALL
Simply remove the two jumpers from CN4, as shown in Figure 10 and connect the application to the CN6 debug connector according to Table 5. With 5V referring to the Nucleo F401RE reference manual & STM32F401RE datasheet VDD 3.3. Install the Nucleo USB driver available on to connecting the board.
NUCLEO F401RE REFERENCE MANUAL SERIAL
The STMicroelectronics STM32F401RE is a Core - ARM 32-bit Cortex-M4 CPU with FPU - Adaptive real-time accelerator (ART Accelerator) - 84 MHz maximum frequency, 105 DMIPS/1.25 DMIPS/MHz - Memory protection unit - DSP instructions Memories - Up to 512 Kbytes of Flash memory - 96 Kbytes of SRAM Clock, reset and supply management - 1.7 V (PDR OFF) or 1.8 V (PDR ON) to 3.6 V application supply and I/Os - POR, PDR, PVD and BOR - 4 to 26 MHz crystal oscillator - Internal 16 MHz factory-trimmed RC - 32 kHz oscillator for RTC with calibration - Internal 32 kHz RC with calibration 1x12-bit, 2.4 MSPS A/D converter: up to 10 channels General-purpose DMA - 16-stream DMA controllers with FIFOs and burst support Up to 10 timers - up to six 16-bit - two 32-bit timers up to 84 MHz - two watchdog timers (independent and window) Debug mode - Serial wire debug (SWD) & JTAG - Cortex-M4 Embedded Trace Macrocell Up to 81 I/O ports with interrupt capability - All IO ports 5 V tolerant - Up to 78 fast I/Os up to 42 MHz Up to 12 communication interfaces - Up to 3 x I2C interfaces - Up to 3 USARTs (2 x 10.5 Mbit/s, 1 x 5.25 Mbit/s), ISO 7816, LIN, IrDA, modem control) - Up to 4 SPIs (up to 42 Mbits/s at fCPU = 84 MHz) - SDIO interface Advanced connectivity - USB 2.0 full-speed device/host/OTG controller with on-chip PHY CRC calculation unit 96-bit unique ID RTC: subsecond accuracy, hardware calendar. 6.3.4 Using ST-LINK/V2-1 to program and debug an external STM32 application It is very easy to use the ST-LINK/V2-1 to program the STM32 on an external application. Device summary Reference NUCLEO-XXXXRX May 2014 DocID025838 Rev 4.
Home / Device Database ® STMicroelectronics STM32F401RE STM32F103RBT6 reference manual datasheet, cross reference, circuit and application. File File history File usage NUCLEO-F401RESchematic.pdf (file size: 1.
0 kommentar(er)
